※ Features: This equipment is a special drilling machine for processing process positioning holes before numerical control drilling of double-sided printed circuit boards. The machine adopts medium frequency electric spindle, featuring high speed, low noise, good drilling accuracy and long service life. Five drillable boards each time (underlay Allegro+3 circuits
※ Features:
This equipment is a special drilling machine for positioning holes of double-sided printed circuit board before NC drilling. The machine adopts medium frequency electric spindle, featuring high speed, low noise, good drilling accuracy and long service life. Each time, five drillable boards (upper pad flash board+3 circuit boards+lower pad board) have a hole diameter of 3.175MM, and the drilling and pin installation can be completed at one time. The depth can be adjusted at will. The equipment is controlled by Panasonic PLC, with stable performance, safety and reliability, and the quality reaches the advanced level of domestic similar products.
※ Specification:
1. Spindle speed: 24000 rpm, infinitely adjustable.
2. Intermediate frequency power supply: frequency converter
3. Spindle spring clamp: 3.175 (inch 1/8 inch)
4. Drillable printed board: maximum size 660MM * 560MM minimum size 200MM * 150MM
5. Power supply and power: single-phase 220V/50HZ 0.5KW
6. Demand air source: 5-7KG
7. Overall dimension of equipment: L1130MM * W680MM * H1460MM
8. Adopt PLC (controller)